Prototype Thermal Design for a 256 Pixel Transition Edge Sensor Bolometer Array with Additional on-chip Cooling

Published

December 16, 2009

Author(s)

Galen C. O'Neil, Joel N. Ullom, Peter J. Lowell

Abstract

Normal-metal/insulator/superconductor (NIS) tunnel junctions can be integrated with transition edge sensor (TES) bolometers to provide additional cooling to the sensor. For example, a TES array cooled to 300~mK by a He$^3$ refrigerator could be enhanced with additional on-chip NIS cooling that decreases the effective bath temperature of each TES to 100~mK. The noise of the array with on-chip cooling would be $\sim$40\% lower than a similar array without on-chip cooling. Additionally, the lower bath temperature allows a more physically robust design with the same saturation power per pixel. However, on-chip NIS cooling does not come for free. While the NIS coolers reduce the bath temperature seen by each pixel, they also dissipate about 100 times as much power as the pixel alone and increase the fabrication complexity. We describe a potential thermal design of a 256 pixel TES bolometer array with on-chip cooling. We show that such an array is feasible despite the increase in thermal power dissipation.

Volume

1185

Issue

1

Conference Dates

July 20-24, 2009

Conference Location

Palo Alto, CA

Conference Title

Low Temperature Detectors 13

Pub Type

Conferences

Download Paper

Local Download

Keywords

Millimeter receiver, TES bolometer, Green Bank Telescope, Microrefrigerator, Normal-insulator-superconductor tunnel junction

Citation

O'Neil, G. , Ullom, J. and Lowell, P. (2009), Prototype Thermal Design for a 256 Pixel Transition Edge Sensor Bolometer Array with Additional on-chip Cooling, Low Temperature Detectors 13, Palo Alto, CA, [online], https://tsapps.nist.gov/publication/get_pdf.cfm?pub_id=903249 (Accessed December 21, 2024)